Configuration File Management Commands; Backup Startup-Configuration; Configuration Commit - HP FlexFabric 7900 Series Command Reference Manual

Configuration file management
commands
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for
features, commands, and parameters might differ in FIPS mode and non-FIPS mode. For more
information about FIPS mode, see Security Configuration Guide.
Unless otherwise stated, the term "MPU" collectively refers to the switching fabric modules on the
HPE 7910/HPE 7910 TAA switch and the built-in MPU on the HPE 7904/HPE 7904 TAA switch.

backup startup-configuration

Use backup startup-configuration to back up the main next-startup configuration file to a TFTP
server.
Syntax
backup startup-configuration to tftp-server [ dest-filename ]
Views
User view
Predefined user roles
network-admin
mdc-admin
Parameters
tftp-server: Specifies a TFTP server by its IPv4 address or host name. The host name is a
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
dest-filename: Specifies the target file name used for saving the file on the server. The file name
must use the .cfg extension. If you do not specify a target file name, the source file name is used.
Usage guidelines
This command is not supported in FIPS mode.
Examples
# Back up the main next-startup configuration file to the TFTP server at 2.2.2.2, and set the target file
name to 192-168-1-26.cfg.
<Sysname> backup startup-configuration to 2.2.2.2 192-168-1-26.cfg
Backup next startup-configuration file to 2.2.2.2, please wait...finished
Related commands
restore startup-configuration

configuration commit

Use configuration commit to commit the settings configured after the configuration commit
delay command was executed.
Syntax
configuration commit
140