Flow-Control; Free Line - HP FlexFabric 7900 Series Command Reference Manual

2 packet(s) transmitted
2 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/3/3 ms
<Sysname>

flow-control

Use flow-control to configure the flow control mode.
Use undo flow-control to restore the default.
Syntax
flow-control { hardware | none | software }
undo flow-control
Default
The flow control mode is none.
Views
User line view
Predefined user roles
network-admin
mdc-admin
Parameters
hardware: Performs hardware flow control.
none: Disables flow control.
software: Performs software flow control.
Usage guidelines
This command is not supported in VTY line view.
The device supports flow control in both the inbound and outbound directions:
•
For flow control in the inbound direction, the local device listens to flow control information from
the remote device.
•
For flow control in the outbound direction, the local device sends flow control information to the
remote device.
The flow control setting takes effect in both directions.
To communicate, two devices must be configured with the same flow control mode.
Examples
# Configure software flow control in the inbound and outbound directions for user line AUX 0.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] flow-control software

free line

Use free line to release a user line.
25