Switchto Mdc - HP FlexFabric 7900 Series Command Reference Manual

[Sysname-mdc-2-sub1] location slot 3
# In IRF mode, authorize MDC sub1 to use the LPU in slot 3 on IRF member device 2.
<Sysname> system-view
[Sysname] mdc Admin
[Sysname-mdc-1-Admin] undo location chassis 2 slot 3
The configuration associated with the specified slot of MDC will be lost. Continue? [Y/N]:y
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] location chassis 2 slot 3

switchto mdc

Use switchto mdc to log in to a non-default MDC from the system view of the default MDC and enter
MDC user view.
Syntax
switchto mdc mdc-name
Views
System view
Predefined user roles
network-admin
network-operator
Parameters
mdc-name: Specifies the MDC name, a case-sensitive string of 1 to 15 characters. The MDC must
have already been started.
Usage guidelines
You use this command to log in only to an MDC that is in active state.
Examples
# Log in to MDC sub1 from the system view of the default MDC. Then, you can stop the automatic
configuration procedure as prompted to enter user view of the MDC and execute commands.
<Sysname> system-view
[Sysname] switchto mdc sub1
******************************************************************************
* Copyright (c) 2010-2016 Hewlett Packard Enterprise Development LP
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
Automatic configuration is running, press CTRL_D to break or press CTRL_B to
switch back to the default MDC.
<Sysname>
<Sysname> display mdc
ID
2
Related commands
switchback
Name Status
sub1 active
267
*
*
*