HP FlexFabric 7900 Series Command Reference Manual page 157

Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Usage guidelines
Current startup configuration file is the configuration file that has been loaded. Next-startup
configuration file is the configuration file used at the next startup.
In standalone mode on an HPE 7910/HPE 7910 TAA switch, the standby MPU always uses the
same current startup configuration file as the active MPU. After an active/standby switchover, it is
normal that the current startup configuration files on them are displayed as NULL. This is because
the new active MPU continues to run with the running configuration rather than rebooting with the
previous current startup configuration file.
In IRF mode, the global standby MPUs always use the same current startup configuration file as the
global active MPU. After an active/standby switchover, it is normal that the current startup
configuration files on them are displayed as NULL. This is because the new global active MPU
continues to run with the running configuration rather than rebooting with the previous current startup
configuration file.
Examples
# (In standalone mode.) Display startup configuration files on an HPE 7910/HPE 7910 TAA switch.
<Sysname> display startup
MainBoard:
Current startup saved-configuration file: flash:/startup.cfg
Next main startup saved-configuration file: flash:/startup.cfg
Next backup startup saved-configuration file: NULL
Slot 11:
Current startup saved-configuration file: flash:/startup.cfg
Next main startup saved-configuration file: flash:/startup.cfg
Next backup startup saved-configuration file: NULL
Table 19 Command output
Field
MainBoard
Current startup saved-configuration file
Next main startup saved-configuration file
Next backup startup saved-configuration file
Slot n
# (In IRF mode.) Display startup configuration files on an HPE 7910/HPE 7910 TAA IRF fabric.
<Sysname> display startup
MainBoard:
Current startup saved-configuration file: NULL
Next main startup saved-configuration file: flash:/startup.cfg
Next backup startup saved-configuration file: flash:/startup2.cfg
Description
Displays the startup configuration files on the active MPU.
Configuration file that the active MPU has started up with.
Primary startup configuration file to be used at the next
startup.
Backup startup configuration file to be used at the next
startup.
Displays the startup configuration files on the standby MPU
in slot n.
149