Send; Set Authentication Password - HP FlexFabric 7900 Series Command Reference Manual

send

Use send to send messages to user lines.
Syntax
send { all | number1 | { aux | vty } number2 }
Views
User view
Predefined user roles
network-admin
mdc-admin
Parameters
all: Specifies all user lines.
number1: Specifies the absolute number of a user line. The value range is 0 to 65 in standalone
mode and 0 to 71 in IRF mode.
aux: Specifies the AUX line.
vty: Specifies the VTY line.
number2: Specifies the relative number of a user line. The value ranges are as follows:
AUX line—0 to 1 in standalone mode and 0 to 7 in IRF mode.
•
VTY line—0 to 63.
•
Usage guidelines
To end a message, press Enter. To cancel a message and return to user view, press Ctrl+C.
Examples
# Before you restart the device, send a notification to VTY 1 to inform the user.
<Sysname> send vty 1
Input message, end with Enter; abort with CTRL+C:
Your attention, please. I will reboot the system in 3 minutes.
Send message? [Y/N]:y
The message should appear on the screen of the user's configuration terminal, as shown in the
following example:
[Sysname]
***
***
***Message from vty0 to vty1
***
Your attention, please. I will reboot the system in 3 minutes.

set authentication password

Use set authentication password to set a password for password authentication.
Use undo set authentication password to remove the password.
35