Telnet Server Dscp; Telnet Server Enable - HP FlexFabric 7900 Series Command Reference Manual

Examples
# Permit only the user at 1.1.1.1 to Telnet to the device.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 1.1.1.1 0
[Sysname-acl-basic-2001] quit
[Sysname] telnet server acl 2001

telnet server dscp

Use telnet server dscp to set the DSCP value for IPv4 to use for outgoing Telnet packets on a Telnet
server.
Use undo telnet server dscp to restore the default.
Syntax
telnet server dscp dscp-value
undo telnet server dscp
Default
IPv4 uses the DSCP value 48 for outgoing Telnet packets on a Telnet server.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63.
Usage guidelines
This command is not supported in FIPS mode.
The DSCP value is carried in the ToS field of an IP packet, and it indicates the transmission priority of
the packet.
Examples
# Set the DSCP value for IPv4 to use for outgoing Telnet packets to 30 on a Telnet server.
<Sysname> system-view
[Sysname] telnet server dscp 30

telnet server enable

Use telnet server enable to enable the Telnet server feature.
Use undo telnet server enable to disable the Telnet server feature.
Syntax
telnet server enable
undo telnet server enable
42