Save - HP FlexFabric 7900 Series Command Reference Manual

src-filename: Specifies the file name of the configuration file to be downloaded.
Usage guidelines
This command is not supported in FIPS mode.
Before restoring the configuration file for the next startup, make sure the following requirements are
met:
•
The server is reachable.
•
The server is enabled with TFTP service.
•
You have read and write permissions to the server.
This command provides an easy method for configuration file restoration by automatically
performing all operations required for restoring the main next-startup configuration file.
This command downloads the configuration file to the root directory of the default storage medium on
each MPU and specifies the file as the main next-startup configuration file.
If a partitioned USB disk is used, make sure the specified file is saved to the root directory of the first
partition on the USB disk.
This command assumes that all MPUs use the same type of default storage medium. If a standby
MPU uses a different type of default storage medium than the active MPU, the command cannot
propagate the configuration file to the standby MPU. For example, the standby MPU uses a USB
disk, but the active MPU uses a flash memory. In this situation, you must manually restore the
next-startup configuration file on the standby MPU.
Examples
# (In standalone mode.) Download the configuration file config.cfg from the TFTP server at 2.2.2.2
and specify the file as the main next-startup configuration file.
<Sysname> restore startup-configuration from 2.2.2.2 config.cfg
Restoring the next startup-configuration file from 2.2.2.2. Please wait...finished.
Now restoring the next startup-configuration file from main board to backup board. Please
wait...finished.
# (In IRF mode.) Download the configuration file config.cfg from the TFTP server at 2.2.2.2 and
specify the file as the main next-startup configuration file.
<Sysname> restore startup-configuration from 2.2.2.2 config.cfg
Restoring the next startup-configuration file from 2.2.2.2. Please wait...finished.
Now restoring the next startup-configuration file from main board to backup board. Please
wait...finished.
Related commands
backup startup-configuration

save

In standalone mode:
Use save file-url [ all | slot slot-number ] to save the running configuration to a configuration file,
without specifying the file as a next-startup configuration file.
Use save [ safely ] [ backup | main ] [ force ] to save the running configuration to a file in the root
directory of the default storage medium. This command specifies the file as a next-startup
configuration file at the same time. For an HPE 7910/HPE 7910 TAA switch, this command applies to
both the active and standby MPUs.
In IRF mode:
Use save file-url [ all | chassis chassis-number slot slot-number ] to save the running configuration
to a configuration file, without specifying the file as a next-startup configuration file.
153