Use this command to verify the application result of preprovisioned commands except for the
following commands:
•
duplex
•
location
•
speed
•
sflow
To verify the application result of the listed commands, use the display current-configuration
command. The display provision failed-config command might display incorrect application
results for the listed commands.
Examples
# Display preprovisioned commands that were not applied.
<Sysname> display provision failed-config
Configuration applied at: Sat Jun 14 06:06:00 2014
Slot information: chassis 1 slot 1
Commands that failed to be applied:
#
interface FortyGigE1/1/0/1
speed 40000
#
Related commands
provision
provision
Use provision to enable preprovisioning for a slot.
Use undo provision to disable preprovisioning for a slot.
Syntax
provision model model
undo provision model
Default
Preprovisioning is disabled.
Views
Slot view
Predefined user roles
network-admin
mdc-admin
Parameters
model model: Specifies the card model to be preprovisioned. To obtain available models, enter
provision model ?.
Usage guidelines
This command allows you to preconfigure interfaces on an offline module.
274