Telnet - HP FlexFabric 12900 series Command Reference Manual

Default
One stop bit is used.
Views
User line view
Predefined user roles
network-admin
Parameters
1: Uses one stop bit.
1.5: Uses one and a half stop bits. The device does not support using one and a half stop bits. If you
specify this keyword, two stop bits are used.
2: Uses two stop bits.
Usage guidelines
This command is not supported in VTY line view.
The configuration terminal and the device must be configured to use the same number of stop bits to
communicate.
Examples
# Set the number of stop bits to 1 for user line AUX 0.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] stopbits 1

telnet

Use telnet to Telnet to a host in an IPv4 network.
Syntax
telnet remote-host [ service-port ] [ vpn-instance vpn-instance-name ] [ source { interface interface-type
interface-number | ip ip-address } ] [ dscp dscp-value ]
Views
User view
Predefined user roles
network-admin
Parameters
remote-host: Specifies the IPv4 address or host name of a remote host. A host name can be a
case-insensitive string of 1 to 253 characters. Valid characters for a host name include letters, digits,
hyphens (-), underscores (_), and dots (.).
service-port: Specifies the TCP port number for the Telnet service on the remote host. The value range is
0 to 65535 and the default is 23.
vpn-instance vpn-instance-name: Specifies the VPN instance to which the remote host belongs, where
vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the remote host belongs to the public
network, do not specify this option.
39