Bootrom Backup - HP FlexFabric 12900 series Command Reference Manual

The main images list is used if the active MPU or global active MPU started up with the main startup
•
images.
The backup image list is used if the active MPU or global active MPU started up with the main
•
startup images.
The startup images synchronized to the standby MPU are set as main startup images, regardless of
whether the source startup images are main or backup.
To avoid problems, make sure the image list used for synchronization is the same as the current software
images list.
Startup image synchronization fails if any software image being synchronized is not available or is
corrupted.
Examples
# In standalone mode, synchronize startup images from the active MPU to the standby MPU in slot 16.
<Sysname> boot-loader update slot 16
This command will update the specified standby MPU. Continue? [Y/N]:y
Updating. Please wait...
Copying main startup software images to slot 16. Please wait...
Done.
Setting copied images as main startup software images for slot 16...
Done.
Successfully updated the startup software images of slot 16.
# In IRF mode, synchronize startup images from the global active MPU to the MPU in slot 16 on IRF
member device 1.
<Sysname> boot-loader update chassis 1 slot 16
This command will update the specified standby MPU. Continue? [Y/N]:y
Updating. Please wait...
Copying main startup software images to chassis 1 slot 16. Please wait...
Done.
Setting copied images as main startup software images for chassis 1 slot 16...
Done.
Successfully updated the startup software images of chassis 1 slot 16.
Related commands
display boot-loader

bootrom backup

Use bootrom backup to back up the BootWare image in the Normal area to the Backup area on a
BootWare.
Syntax
In standalone mode:
bootrom backup slot slot-number-list
In IRF mode:
bootrom backup chassis chassis-number slot slot-number-list
155