Startup Saved-Configuration - HP FlexFabric 12900 series Command Reference Manual

Save next configuration file successfully.
Related commands
• display current-configuration
display saved-configuration
•

startup saved-configuration

In standalone mode:
Use startup saved-configuration to specify a file as a next-startup configuration file for both active and
standby MPUs.
Use undo startup saved-configuration to set the active and standby MPUs to start up with initial settings
at the next startup.
In IRF mode:
Use startup saved-configuration to specify a file as a next-startup configuration file for all MPUs in the IRF
fabric.
Use undo startup saved-configuration to set all MPUs to start up with initial settings at the next startup.
Syntax
startup saved-configuration cfgfile [ backup | main ]
undo startup saved-configuration
Default
No configuration file is specified for the next startup.
Views
User view
Predefined user roles
network-admin
Parameters
cfgfile: Specifies the name of a .cfg file. This .cfg file must already exist in the root directory of the default
storage medium.
backup: Specifies the configuration file as the backup next-startup configuration file.
main: Specifies the configuration file as the main next-startup configuration file. This is the primary
configuration file that the device attempts to load at startup. If the loading attempt fails, the device tries
the backup next-startup configuration file.
Usage guidelines
CAUTION:
In an IRF fabric, use the undo startup saved-configuration command with caution. This command can
cause an IRF split after the IRF fabric or an IRF member reboots.
The startup saved-configuration command applies to each MPU. To successfully configure the command,
follow these guidelines:
150