Sysname - HP FlexFabric 12900 series Command Reference Manual

bandwidth and reduces the forwarding performance. To minimize impact on forwarding performance,
isolate only the failed channels.
Isolating a switching fabric module or channel does not affect operations on the control panel, such as
protocol packet resolution and protocol calculation. The switching fabric module or channel can forward
traffic immediately after you cancel the isolation.
Examples
# In standalone mode, isolate the switching fabric module in slot 10.
<Sysname> system-view
[Sysname] switch-fabric isolate slot 10
The command will isolate the switch fabric or a channel from the system. Continue? [Y/N]
# In IRF mode, isolate channel 1 on the switching fabric module in slot 10 of member device 1.
<Sysname> system-view
[Sysname] switch-fabric isolate chassis 1 slot 10 channel 1
The command will isolate the switch fabric or a channel from the system. Continue? [Y/N]

sysname

Use sysname to set the device name.
Use undo sysname to restore the default.
Syntax
sysname sysname
undo sysname
Default
The default name is HP.
Views
System view
Predefined user roles
network-admin
Parameters
sysname: Specifies a name for the device, a string of 1 to 64 characters.
Usage guidelines
A device name identifies a device in a network and is used as the user view prompt at the CLI. For
example, if the device name is Sysname, the user view prompt is <Sysname>.
Examples
# Set the name of the device to R2000.
<Sysname> system-view
[Sysname] sysname R2000
[R2000]
243