Diagnostic Start Test - HP FlexFabric 12900 series Command Reference Manual

[Sysname] undo copyright-info enable
• When a Telnet user logs in, the user view prompt appears:
<Sysname>
When a console user quits user view, the following message appears (the device automatically tries
•
to restart the console session):
User interface aux0 is available.
Press ENTER to get started.

diagnostic start test

Use diagnostic start test to run a global on-demand diagnostic test.
Syntax
diagnostic start test test-name
Views
User view
Predefined user roles
network-admin
Parameters
test test-name: Specifies a test by its name, a case-insensitive string of 1 to 31 characters.
Usage guidelines
This command is available only when the device operates in standalone mode.
Before you execute this command, start the device with factory defaults and verify that no service ports
are connected to any cables and transceiver modules.
After you execute this command, you must reboot the device.
Examples
# Run a global on-demand diagnostic test.
<Sysname>diagnostic start test EquipSelfCheck
This command requires null configuration and reboot device aferwards. Continue?
[Y/N]:y
=================================================
===============display clock===================
10:55:19 UTC Fri 06/27/2014
===============system-view=====================
System View: return to User View with Ctrl+Z.
===============undo stp enable=====================
===============probe-view=====================
===========undo monitor inner-channel=================
188