6. Reinstall the bushings on the carriage
shaft.
7. Attach the timing belt to the timing belt clip
as shown in Figure 4-20.
Timing belt clip
Timing belt
Figure 4-20 Attaching timing belt to
carrier
8. Reattach the carrier and shaft assembly to the
printer.Position the bushings as shown in
Figure 4-21.
Pointer
Index marks
Figure 4-21 Bushing position
Page 4-18
Ensure the ribbon cable is not twisted
after the carrier has been reinstalled in
note
it's normal operating position.
9. Wrap the timing belt around the encoder gear,
and then around the carriage motor gear.
10. When the timing belt is seated correctly, slide the carrier
back and forth along the shaft. It should move
freely with no binding.
www.printcopy.info
Xerox WorkCentre 450c/450cp Service Manual