Rep 2.1.6: Paper Out Sensor - Xerox 450c Service Manual

REP 2.1.6: Paper Out Sensor

Parts List: 5.1
The paper out sensor is located inside the paper
cassette.
1. Remove the paper cassette from the
WorkCentre.
2. Push in on either side of the inner bracket.
See Figure 4-6.
Push in on bracket
Figure 4-6 Releasing the paper cassette
bracket
3. Remove the switch from the slot in the paper
cassette.
Xerox WorkCentre 450c/450cp Service Manual
4. Turn the cassette over and unsnap the back of the cassette.
Use a small flat-bladed screwdriver to release the tabs.
See Figure 4-7.
Insert screwdriver here
to release tabs
Figure 4-7 Paper cassette (rear)
5. Disconnect the wiring harness from the two contacts
in the paper cassette. See Figure 4-8.
Figure 4-8 Paper out switch wiring harness
connections
www.printcopy.info
Disconnect
harness
Page 4-9