Xerox 450c Service Manual page 17

System Check (continued)
Continue the Initial Actions flowchart on
this page to check the scanner assembly,
LCU, and fax capabilities.
Xerox WorkCentre 450c/450cp Service Manual
System Check: Copier Test
Make a copy. Insert the Xerox Test
Print (p/n 82P151) into the document
feeder. Document feeds part way
into the scanner and stops.
YES
The following message appears
on the LCD:
Dial number, COPY or
press START to store
Press COPY. The following
message appears on the LCD:
1 Copy Size: 95%
Press START to copy
Press START. The following
message appears on the LCD:
Copying... 01
xx% free
The document feeds all the
way through the scanner. The
scanner motor stops after the
document ejects.
Paper feed motor activates and
feeds paper correctly?
Continued on following page
www.printcopy.info
Scanner motor does not
NO
activate or document feeds
incorrectly. Go to Doc and Read
Point Sensor RAP 5.1.
If no message appears on the
LCD, go to LCD RAP 7.2.
If any other message displays,
go to the Messages RAP 1.1.
If no message appears on the
LCD, go to LCD RAP 7.2.
If any other message displays,
go to the Messages RAP 1.1.
If no message appears on the
LCD, go to LCD RAP 7.2.
If any other message displays,
go to the Messages RAP 1.1.
Go to Doc and Read Point
Sensor RAP 5.1.
Go to Paper Feed RAP 3.1.
Page 1-5