REP 2.1.9: Wiper REP
Parts List: 2.1
Note: Later models of the WorkCentre
450c/450cp may only have one wiper.
1. Perform the following:
a.
REP 1.1: WorkCentre Cover on page 4-3
2. Move the printhead carriage to the middle of
the printer.
3. Pull out each of the two wipers (Figure 4-13).
You can use your fingers or a pair of
needlenose pliers.
Wipers
Figure 4-13 Wipers
4. Carefully push in the two new wipers. Make
sure they are seated properly within the slots.
Page 4-12
www.printcopy.info
Xerox WorkCentre 450c/450cp Service Manual