Xerox WorkCentre 450c Reference Manual

CUSTOMER SELF SERVICE
Feed Roll Cleaning Kit
Xerox -
DOCUMENT
The purpose of the instructions is to provide a step by step procedure to correct a paper feed problem. Read all
the instructions before performing this procedure.
Contents of kit:
CUSTOMER PREPARATION:
Unpack the repair kit and read the Repair Instructions.
F
NOTE: Good lighting is required in order to
see inside the WorkCentre
ü
q
Check off the box after each Step is completed.
q
1. Remove all paper and the clear plastic Printer
Output Tray in front of the paper tray. (See Figure 1)
q
2. Insert approximately a ¼ inch thick stack of
20 lb. paper (measure it) into the Paper Tray.
q
3. Insert the Feed Roll Cleaning Pad (provided in
Kit) in front of the paper stack (Long-Edge-Down) with
the green side (coarse side) facing out.
709P00850 Rev A
WorkCentre
Feed Roll Cleaning Pad
450c / 450cp
(continued)
March 2000
DRB-FILE
450c / 450cp
Repair Instructions
Step 1:
Remove all
paper and the
clear plastic
Printer Output
Tray
Printer Output
Tray
Bottom of
Paper Tray
Figure 1. Inserting the Feed Roll Cleaning Pad
into the Paper Tray
¼ inch Paper
Stack
Feed Roll
Cleaning Pad
with the green
side facing out
Step 2:
Insert approximately a ¼
inch thick stack of paper
into the Paper Tray and
insert the Feed Roll
Cleaning Pad in front of the
paper stack with the green
side facing out
3 Feed Rolls are in
front of the Pad
Page 1 of 2