Xerox 450c Service Manual page 29

WorkCentre 450c/450cp LCD Panel Messages (Continued)
Message
No cyan ink. Load Either the cyan ink cartridge is
cartridge. missing or an ink cartridge made
for another machine is installed
in the WorkCentre.
No magenta ink. Load Either the magenta ink cartridge
cartridge. is missing or an ink cartridge
made for another machine is
installed in the WorkCentre.
No yellow ink. Load Either the yellow ink cartridge is
cartridge. missing or an ink cartridge made
for another machine is installed
in the WorkCentre.
Open cover or press The document either remained in
EXIT to clear scanner. the document tray or was
partially fed into the scanner.
Out of paper. Please The WorkCentre is out of paper.
add paper.
Paper misfeed or jam. The paper did not load properly
Press Feed to clear. into the printer.
PC error. Reload pages. While using a PC application to
scan a document, an error
occurred.
PC error. Try again. While using a PC application to
print or scan a document, an
error occurred.
PC not connected. The WorkCentre cannot
communicate with your PC.
Printer error. Clear, then The WorkCentre has
reset. encountered a printer error.
Xerox WorkCentre 450c/450cp Service Manual
Meaning
Insert a Xerox color ink cartridge.
Insert a Xerox color ink cartridge.
Insert a Xerox color ink cartridge.
Press EXIT/CLEAR to clear the document, or
open the scanner cover and remove the
document.
Load up to 150 sheets of paper in the paper
tray.
Press the FEED key to clear the misfed or
jammed paper.
Reload the document in the document tray
and try scanning again.
Retry the task. If you receive the error
message again, restart your PC.
Do one or more of the following:
1. Make sure power is supplied to both the
WorkCentre and your PC.
2. Make sure the printer cable connects the
WorkCentre to your PC.
3. Turn your PC off, then turn it on.
Power off, then power on the WorkCentre.
Operator Action
www.printcopy.info
Technician Action
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 5.1: Doc and Read Point Sensor on page 2-
30
Go to RAP 3.7: Paper Out Sensor on page 2-23
Go to RAP 3.1: Paper Feed on page 2-16
Go to RAP 6.2: PC Connectivity on page 2-34
Go to RAP 6.2: PC Connectivity on page 2-34
Go to RAP 6.2: PC Connectivity on page 2-34
Power off, then power on the WorkCentre. If the same
message appears, perform RAP 4.2: Encoder on page
2-27 or RAP 3.1: Paper Feed on page 2-16. If any other
message appears, perform the Technician Action for
that message.
Page 2-5