Xerox 450c Service Manual page 30

WorkCentre 450c/450cp LCD Panel Messages (Continued)
Message
Printer unavailable. The WorkCentre cannot print the
documents stored to memory, or
is in use.
Printer paper jam. Press There is a paper jam in the
to clear. printer.
FEED
Scanner cover open. Either the scanner cover is open
Clear pages and close. or you opened it while the
WorkCentre was scanning a
document.
Scanner jam/long You did not press START to fax a
original: No reply. long document. The WorkCentre
canceled the job.
Scanner jam. Open The document did not load into
cover to clear. the scanner properly.
Scanner not available. You tried to copy or scan a
document while the scanner was
unavailable.
Will redial. No dial tone. The WorkCentre could not detect
Check line. a line current or dial tone. The
WorkCentre will redial the
number.
Yellow low. Start if OK, The ink supply in the yellow ink
or Cartridge. cartridge is low.
Page 2-6
Meaning
Do one or more of the following:
1. Make sure paper is loaded in the paper
tray.
2. Make sure a print head or cartridge is
installed.
3. Make sure the printer cable connects the
WorkCentre to your PC.
4. Clear any printer jams.
5. Wait until the current print job finishes.
Press and hold the
Press EXIT/CLEAR to remove any pages
from the scanner, and then close the scanner
cover.
Resend the long document, or if there is a
scanner jam, press EXIT/CLEAR to clear it.
Remove your originals from the document
tray. Open the scanner cover and remove the
misfed page. Close the cover and reload the
document.
Do one or more of the following:
1. Make sure the scanner cover is closed.
2. Clear any scanner jams by pressing the
EXIT/CLEAR key.
3. Open the scanner cover to manually
remove any jammed pages.
Do one or more of the following:
1. Make sure the WorkCentre is connected to
a telephone wall plug.
2. Make sure your telephone or answering
machine is connected to the WorkCentre.
Check the printed pages. If the print quality is
good, press START to clear the message and
continue using the cartridge. If the print
quality is not good, replace the yellow ink
cartridge.
Operator Action
key to clear the jam. Go to RAP 3.1: Paper Feed on page 2-16
FEED
www.printcopy.info
Technician Action
Go to RAP 3.1: Paper Feed on page 2-16
Replace Scanner Cover Open switch (REP 4.1.6:
Scanner Cover Open Switch on page 4-36.
Go to RAP 5.1: Doc and Read Point Sensor on page 2-
30
Go to RAP 5.1: Doc and Read Point Sensor on page 2-
30
Go to RAP 5.1: Doc and Read Point Sensor on page 2-
30
Go to RAP 6.1: Analog Communications on page 2-33
Go to RAP 4.3: Ink Level Sensor on page 2-28
Xerox WorkCentre 450c/450cp Service Manual