Xerox 450c Service Manual page 28

WorkCentre 450c/450cp LCD Panel Messages (Continued)
Message
Cyan low. START if OK, The ink supply in the cyan ink
or CARTRIDGE. cartridge is low.
If long document, The WorkCentre detected a long
START to continue. Or document in the document tray
press EXIT to clear or there is a scanner jam.
scanner jam.
Ink low. START if OK or The ink in the high capacity ink
CARTRIDGE key. jet cartridge is low.
Job will start when The WorkCentre is busy sending
phone is available. or receiving a fax. When the
telephone line is free, the job will
start.
Job will start when You tried to retrieve a document
printer is available. from another fax machine when
the printer was unavailable and
the If cannot print option is set
to do not answer .
Load cartridge or color A high capacity ink jet cartridge
print head. or color print head is not
installed in the WorkCentre.
Magenta low. START if The ink supply in the magenta
OK, or CARTRIDGE. ink cartridge is low.
Memory full. Reload The WorkCentre ran out of
unscanned pages. memory during scanning.
Memory full. <reason> There isn't enough WorkCentre
memory to complete the desired
operation
Page 2-4
Meaning
Check the printed pages. If the print quality is
good, press
continue using the cartridge. If the print
quality is not good, replace the cyan ink
cartridge.
If you are faxing a long document, press
START . If there is a scanner jam, remove your
originals from the document tray, and then
press
EXIT/CLEAR
scanner cover and remove the misfed page.
Check the printed pages. If the print quality is
good, press START to clear the message and
continue using the cartridge. If the print
quality is not good, replace the high capacity
ink jet cartridge.
No action.
Try again when the printer is available. Set If
cannot print to receive to memory to retrieve
the document to memory if the printer
becomes unavailable again.
Install a high capacity ink jet cartridge or color
print head.
Check the printed pages. If the print quality is
good, press START to clear the message and
continue using the cartridge. If the print
quality is not good, replace the magenta ink
cartridge.
Increase memory by deleting or printing the
documents stored to memory. Reload the
pages not scanned and restart the job (when
applicable).
Increase memory by deleting or printing the
documents stored to memory, and then try
again.
Operator Action
to clear the message and
START
to clear the jam or open the
www.printcopy.info
Technician Action
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 5.1: Doc and Read Point Sensor on page 2-
30
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 6.1: Analog Communications on page 2-33
Go to RAP 3.1: Paper Feed on page 2-16
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 4.3: Ink Level Sensor on page 2-28
Go to RAP 9.0: RAM Test on page 2-39
Go to RAP 9.0: RAM Test on page 2-39
Xerox WorkCentre 450c/450cp Service Manual