Cisco D9824 Installation And Configuration Manual page 95

Menu Item Description
FEC Type of expected FEC streams for the decoder
to analyze and use.
Src Filter Select the source (host) filtering mode.
TS UDP The transport stream UDP port number. For
RTP port, enter an even port number. For UDP
port, you can enter an even or odd port
number.
Note: FEC is only supported for RTP transport
streams.
FEC1 UDP If FEC is set to 1D or 2D, set the FEC
destination UDP port number of the column
FEC stream.
FEC2 UDP If FEC is set to 2D, in addition to entering the
port number of the column FEC stream, enter
the FEC destination UDP port number of the
row FEC stream.
Source IP Select Displays the detected host.
Setup Menu
Parameters
None - All FEC streams
are dropped.
1D - Column stream is
expected.
2D - Column and row
streams are expected.
None - All streams sent to
a specific destination IP
address (multicast or
unicast) and destination
TS and FEC UDP ports are
received, without source
restrictions.
White List - The unit will
only receive streams from
the defined list of
hosts/servers (Idx and IP
Address). It will reject the
streams received from the
host/servers that are not
defined on the list.
Black List - The unit will
reject the streams received
from the defined list of
hosts/servers (Idx and IP
Address).
1 to 65534
2 to 65534
2 to 65534
Valid host IP address or
0.0.0.0 if none is found.
73