Setting Up Cue Tone Test - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up Cue Tone Test

1 From the user interface of the D9824, choose Audio & Video > Cueing > Cue
Tone Test. The Cue Tone Test page is displayed.
2 In the Test Tones field, enter the three digit tone sequence. You can enter a value
between 000 and 999.
3 From the Sequence Mode drop-down list, choose the tone sequence mode. The
following describes the available options:
* - Start tone only
-
# - End tone only
-
*/# - Start and end tones. The end tone is signaled after waiting the time
-
specified in Delay(sec).
4 Click Apply.
204