Cisco D9824 Installation And Configuration Manual page 103

Protocols
The Protocols menu allows you to control remote access protocols (Telnet, SSH, HTTP, and
SNMP) to the IRD.
Menu Item Description
Telnet Controls Telnet access to the
IRD.
SSH Controls SSH access to the IRD.
HTTP Controls HTTP access to the
IRD.
SNMP Controls SNMP access to the
IRD.
MPE Sets whether the MPE data is
forwarded to the network.
Note: The transcoder supports
up to a maximum of 10 Mbps
throughput when forwarding
1500 byte packets.
Port Number Parameters
TCP port #23 Enable (default) - Allow
Telnet connections.
Disable - Disables the
listener for the Telnet port.
TCP port #22 Enable (default) - Allow
secure shell connections.
Disable - Disables the
listener for the SSH port.
TCP port #80 for Disable - Disables the
HTTP. listener for the HTTP port.
TCP port #443 Enable (default) - Allow
for HTTPS. web connections.
Secure - Encrypted access
to the webserver (HTTPS).
For more information, see
Protocol Control Settings
(on page 247).
UDP port #161 Enable (default) - Allow
SNMP connections.
Disable - Disables the
listener for the SNMP port.
N/A Fwd None - The MPE data
is not forwarded to the
network.
Fwd All - All the MPE data
is forwarded to the
network.
Fwd Filtered - Only the
MPE data from the defined
Static Multicast Filtering
table is forwarded to the
network. For more
information on configuring
the Static Multicast
Filtering table, see To Add a
Static Multicast Filtering
(on page 254).
Setup Menu
81