Setting Up Alarms And Warnings - Cisco D9824 Installation And Configuration Manual

Setting up Alarms and Warnings

To Set Up Alarms
1 From the user interface of the D9824, choose System Settings > Setup. The
Alarm Setup page is displayed.
2 Check the Enable Alarm/Warning Front Panel Reminder check box for the
highest priority alarm to flash on the LCD display for a two-second interval
every 10 seconds. The alarm will continue to flash periodically until it is either
cleared or the Enable Alarm/Warning Front Panel Reminder check box is
unchecked.
3 Check the Enable Video Cutoff on Alarm Condition check box to cut off the
video output if any enabled alarm is active on the receiver. When video is cut off,
there will be no horizontal or vertical synchronization on the output. This is
useful for downstream redundancy switching by detecting a loss of video signal.
4 Click the Trap Configuration link to view and/or modify SNMP trap
destinations. The link will open the SNMP page. For more information, see
Setting up SNMP Information and Trap Destinations (on page 255).
Configuring System Settings
259