Cisco D9824 Installation And Configuration Manual page 186

Chapter 5 Web GUI Setup and Monitoring
Parameter
Signal Status
Input Rate (Mbps)
Acquisition State
Link Status
Port In Use
Transport Stream
Locked Data1/Data2
Source
Switchover Reason
Switchover Date/Time
PCR Lock
De-jitter Latency (msec)
FEC Bitrate (Mbps)
FEC CEC
FEC PER
164
Description
Indicates whether the input signal is locked.
Locked - Indicates the receiver is locked to a carrier

with no valid content.
Lock+Sig - Indicates the receiver is locked to a carrier

with valid content.
No Lock - Indicates the receiver is not locked to a

carrier.
Displays the bit rate of the input transport stream, in Mbps.
Displays Full if the SI and PSI tables have all been found.
Otherwise, it will display Degraded if there are missing tables
or None if no SI or PSI tables have been found.
Displays the link status of the active data port (Up or Down).
Displays the current input port in use (Data1 or Data2).
The Transport ID (in the range from 1 to 65535).
When locked, this displays the source/host IP address of the
originator. If the signal is not locked, it will display N/A.
Displays a description of the reason for the last redundancy
switchover (AV Loss, Program Loss, PCR Loss, Link Loss, TS
Loss, or None).
Displays the last date and time for the last redundancy
switchover.
Indicates whether the system is locked to the required PCR PID
(Yes or No).
Displays the overall transport stream buffer latency, in
milliseconds.
Displays the input stream bit rate reported by the FEC decoder.
Indicates the current Corrected Error Count for the received
stream.
Indicates the current Packet Error Rate of the received stream.