Cisco D9824 Installation And Configuration Manual page 135

Menu Item
Act
OutCh
PMT
PID
Map Mode
Description
Selects the action to perform on
the current program entry.
This setting controls the overall
DPM behavior of the PE and
will affect how the PID
mapping operates.
If mapping the current PE (Act
was set to Map), set the output
channel number for the current
program.
If mapping the current PE (Act
is set to Map), set the output
PID of the PMT.
Press Select to view and
configure the PID map. The PID
map is used to map input
services to output PIDs. For
more information, see PID Map
Menu (on page 116).
Select the DPM mapping mode
for the current output.
Parameters
Pass (default) - Output channel is the
same as the input channel. The
OutCh, and PMT settings are ignored.
All PID map entries are ignored
except for entries that explicitly drop
a service.
Map - The output channel is mapped
to the OutCh and PMT settings. Only
services which have entries in the PID
map are available on the output.
These services will appear in the PMT
even if the stream is not present.
Note: If the PE is mapped, it uses the
last valid input. The output map (for
example, output channel PMT) does
not change automatically if the input
or channel number is changed.
Drop - The current channel is not sent
to the output and its PMT is removed
from the output. The OutCh, PMT,
and PID map entries are ignored.
1 to 65535
2 to 8190
Svc ID - The elementary PIDs are not
changed. Channels are remapped by
changing their PSI references. When
this mode is selected, PID mapping in
the PID Map menu is ignored.
Svc ID & PID - Channels and the
elementary service PIDs can be
mapped using the PID Map menu.
Setup Menu
113