Cisco D9824 Installation And Configuration Manual page 111

16:9 4:3 4:3 CCO
16:9 4:3 4:3 P/B
16:9 4:3 14:9
16:9 4:3 16:9 SCALE
Note: Active Format Descriptor (AFD) - normally it is necessary to set both the TV
Aspect Ratio and Conversion to correctly display the video program on the TV
system. The Auto AFD option enables the receiver output to automatically match the
display format of the video program to the TV system based on specific (uplink)
program information carried in the transport stream. In this case, the receiver
performs the conversion based on the TV Aspect Ratio setting combined with the
program-specific uplink information to provide the "best fit" for display of the
program material on the TV. This feature is primarily used in 16:9 and 14:9 (wide
screen) applications.
Audio
Menu Item Description
Aud# Sets which balanced audio output
on the rear panel to configure.
Stereo/Mono Sets the output mixing.
AC3 Compression Sets the AC3 compression mode to
use if the output is compressed
Dolby Digital audio.
4:3 CCO Horizontally up-samples
the center portion of the
picture to fill the screen.
None Conversion is not
possible. Picture appears
tall and thin.
14:9 Compromises some up-
sampling. Some black
bars and some cropping
are visible.
None Conversion is not
possible. Picture appears
tall and thin.
–
–
Parameters
1 or 2
Stereo - Left and Right are passed
directly through to Left and Right
R-MONO - Right is passed to both the
Left and Right
L-MONO - Left is passed to both the
Left and Right
Mixed - Left is passed to both the Left
and Right, and Right is passed to both
the Left and Right.
Line Mode, Custom 1, Custom 0 or
RF Mode.
RF Mode is recommended for analog
cable modulators.
Setup Menu
89