Cisco D9824 Installation And Configuration Manual page 101

Menu Item Description
SNMP Read Write Sets the password to write data to a
Community String device.
This is used when communicating
with a device within an SNMP
environment.
Reset Credentials If for some reason, you cannot access
the decoder (due to a forgotten
password or corrupted data), the
recovery procedure for the decoder is
as follows:
Using the keypad, choose this field on
the front panel menu. A default login
username and randomly generated
password will be displayed on the
front panel display for approximately
30 seconds. The new account will
have Admin privileges. It is
recommended that this account be
replaced by a login
username/password chosen by the
administrator. To change the
username and password, you must be
an Admin user. Refer to Setting
Admin User Privileges via a
Telnet/SSH Connection (on page 31).
Note: After this recovery procedure,
all existing user accounts will be lost.
Password Sets the password complexity for all
users. The complexity level changes
Complexity
will only affect the new user accounts
and password changes. It will not
affect existing accounts.
SNTP Server Sets the NTP server address. If the
NTP server address is not set (0.0.0.0),
the IRD will not attempt to connect to
the server.
SNTP Enable Periodically request NTP timestamps
from the NTP server and to
synchronize its system (i.e., non-DVB
related) time with the NTP server.
Setup Menu
Parameters
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.
No Checking, Minimal Checking, or
Full Complexity Checking
For more information, see the
Password Complexity table below.
12 digits in length (###.###.###.###)
Yes or No
79