Cisco D9824 Installation And Configuration Manual page 234

Chapter 5 Web GUI Setup and Monitoring
i
ii In the First ES PID Numbers Offset field, enter the offset of the first ES
d From the Use Input PMT ES Stream Order drop-down list, choose Yes to
assign the ES PID according to the incoming PMT order. Otherwise, choose
No to use the reserved PIDs defined below.
i
e Click OK.
4 Click Apply.
Viewing the ASI Output Status
The ASI Output Status area displays the current Output Rate (0 to 213 Mbps) and
the available bit bandwidth (Free Bandwidth), in Mbps.
212
In the First Channel First ES PID Number field, enter the first ES PID
number. The default is 101.
PID of subsequent channel numbers. For example, if the First ES PID
Number is set to 101 and the ES PID Numbers Offset is set to 100, then
the first ES PID number is 101, and the second ES PID number is 201.
In the PCR, VID, AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT,
ETV fields, enter the number of PIDs for the specified streams (PCR, VID,
AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT, ETV) in one
channel.