Cisco D9824 Installation And Configuration Manual page 340

Chapter 6 Service and Maintenance
Alarm Message
Type
Decoder Clear
Processor Start
LEC Timeout Set
LEC Timeout Clear
FPGA status Set
FPGA status Set
FPGA status Set
318
Message Cause/Remedy
Boot passed –
LEC Table Cause: Possible
Missing/timeout:c LEC Server or
hannels currently
Uplink issue.
unavailable
Remedy: Check
LEC Server setup
and uplink
configuration for
the GDS PID
setup. Clear alarm
and notify Cisco
Services if the
problem persists.
LEC received –
FPGA Init failed to Cause: Hardware
go high issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA Init and Cause: Hardware
Done failed to go
issue.
low
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA Init went Cause: Hardware
LOW (CRC error) issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
Description Severity
– Major
ECT Table is Major
not received in
the GDS
stream.
– Major
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
ID
38000
38500
38500
39000
39000
39000