Cisco D9824 Installation And Configuration Manual page 137

Menu Item
PSI Rate
Service ID
PAT, CAT, PMT,
TSDT, NIT, NITO,
SDT, SDTO, BAT,
EIT, TDT, RST, TOT,
DIT, SIT, ECM,
EMM, DRT, CDT
PE Resync: All,
Template, PIDs, Svcs
PAT/PMT Offset
Description
If the PSI Options was set to
Ctrl by Table, select the
regeneration rate for those PSI
tables being regenerated.
Select whether the receiver
should always generate PSI
tables for the Mapped PE even
if the selected input channel is
not available, or for only valid
service channels/IDs.
Selects the tables which will be
passed, dropped, regenerated,
or passed with rate control
(PwRC) from the output. For
more information, see PSI
Table Settings (on page 117).
Note: The table settings are
only available if you selected
Ctl by Table in the PSI Options
menu.
Each PE output can be
synchronized to its input
according to one of four output
modes. For information on
synchronizing output services,
see Synchronizing Output
Services (on page 120).
This is a customer-specifi c
mode, only to be used if
directed by Cisco. For more
information, contact Cisco
customer support.
Parameters
Auto - Matches the generated PSI
tables' output rate to the incoming
rate.
MPEG Min - Transmits the generated
PSI tables on the longest intervals that
are allowed by MPEG standard.
SA Std - Transmits the generated PSI
tables based on PowerVu standard
intervals.
Valid Ch - Only transmits the PSI
tables for the mapped program if the
program exists on the input stream.
All Ch - Transmits the PSI tables for
the mapped program even if the
program does not exist in the input
stream.
All Ch is only valid if the PAT, NIT,
SDT and PMT are set to Regenerate.
Svcs - Map the input to the output
based on the services only.
PIDS - Map the input to the output
based on the PIDs only.
All - Map the input to the output
based on the PIDs and services
Template - Map the input to a fixed
template output.
Setup Menu
115