Cisco D9824 Installation And Configuration Manual page 337

Alarm Message
Type
MPoIP Status Set
MPoIP Status Clear
Boot Host Set
Boot Host Set
Boot Host Set
Message Cause/Remedy
MPEGoIP Cause: Uplink
Overflow. Output settings may have
Muted. Reduce changed since
setup of the unit.
content.
Variable Bit
Rate/Statmuxed
streams may be in
use.
Remedy: Increase
output rate, drop
unreferenced
content in DPM
Options, drop
programs not
needed for
downstream
devices. Contact
the (uplink)
service provider to
verify expected bit
rate settings.
MPEGoIP Output –
Restored
KB not accessible Cause: Hardware
issue
Remedy: Clear
alarms, reset unit,
and notify Cisco
Services if the
problem persists.
LCD not Cause: Hardware
connected issue
Remedy: Clear
alarms, reset unit,
and notify Cisco
Services if the
problem persists.
FLASH Not Cause: Hardware
Found issue
Remedy: Clear
alarms, reset unit,
and notify Cisco
Services if the
problem persists.
Description Severity
Current Minor
transport rate
exceeds
configured rate
for MPEG over
IP output.
Output has
been muted to
protect
downstream
devices.
– Minor
KB is not Major
detected by
Boot code.
LCD is not Major
detected by
Boot code.
Flash memory Major
not detected.
ID
35000
35000
36000
36000
36000
315