Adf Edge Erase - Lexmark 7462 series Service Manual

ADF Edge Erase

This setting sets the size of the no-print area around an ADF scan job.
1
Enter the Configuration menu, and then select ADF Edge Erase.
2
Select a setting.
3
Apply the changes.
FB Edge Erase
This setting sets the size of the no‑print area around a flatbed scan job.
1
Enter the Configuration menu, and then select FB Edge Erase.
2
Select a setting.
3
Apply the changes.
Scanner Manual Registration
Use this setting to register the flatbed and ADF on the scanner. Perform a registration adjustment whenever
the ADF, flatbed, or controller board is replaced.
Note: This setting does not appear if the Disable Scanner setting is set to Auto Disabled.
Enter the Configuration menu, and then select Scanner Manual Registration.
Flatbed registration adjustment
1
Enter the Configuration Menu, and then navigate to:
Scanner Manual Registration > Print Quick Test
2
Remove all the pages from the ADF, place the Quick Test page on the flatbed, and then select Copy Quick
Test.
Do this step to view the current flatbed registration values.
3
Select Flatbed.
The current values of the left margin and top margin registration settings appear.
4
Adjust the left and top margins.
5
Apply the changes.
6
Repeat step 2 to view the updated values.
7
Repeat steps 3 through 5 to make further adjustments.
ADF registration adjustment
1
Enter the Configuration Menu, and then navigate to:
Scanner Manual Registration > Print Quick Test
2
Place the Quick Tests page on the ADF and then select Copy Quick Test.
Do this step to view the current ADF registration values.
Service menus
283
7462