Energy Conserve; Format Fax Storage; Adf Edge Erase; Fb Edge Erase - Lexmark X203N Service Manual

7011-2xx
It is recommended that you first print the customer's current setting's by printing a copy of the Menu setting's
pages. Customer setting's are available from the Ready prompt, Diagnostics Menu setting's are available in the
Diagnostics Menu, and Config Menu setting's are available in the Config Menu.
1.
Turn off the printer, or select Exit Config Menu.
2.
At the Ready prompt, select Menus (
3.
Select Reports, and press Select (
4.
Select Menu setting's Page, and press Select (
5.
Enter the Diagnostic Menu, select Reports, Menu setting's Page, and press Select (
See "Menu setting's Page" on page
6.
Turn off the printer, or select Exit Diags.
7.
Enter Configuration Menu, select Reports, Menu setting's Page, and press Select (
See "Menu setting's Page" on page
To reset factory defaults:
1.
Select Reports from the Config Menu, and press Select (
2.
Select Factory Defaults, and press Select (
3.
Select Restore Base (for locally attached printers) or Restore STD NET (if you have integrated network
support).
Submitting Changes... appears on the operator panel, and then the printer PORs (restarts in Ready mode).

Energy Conserve

Affects the values that appear in the Power Saver menu item in the Setup Menu. This menu item appears only
when the printer model does not support Automatic Power Saver or has deactivated Automatic Power Saver.
The menu item affects only the values that are displayed in the Power Saver menu item.
Select Off in Energy Conserve to allow Power Saver in the customer menu to display Disable as an option. If
Disable is selected in the customer Power Saver, the printer deactivates the Power Saver feature. Select On
(the default) in Energy Conserve to prevent Disable from appearing as an option in the Power Saver setting, and
preventing the customer from turning off Power Saver.

Format Fax Storage

This setting allows the user to format non volatile fax storage memory. While formatting is taking place,
Formatting Fax Flash DO NOT POWER OFF appears. After formatting is complete, the display reverts to the main
menu.

ADF Edge Erase

This menu item sets the size, in millimeters, of the no-print area around an ADF scan job.All copy jobs have a
minimum of a two millimeter border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
1.
In the Configuration menu, select the ADF Edge Erase menu item.
2.
Press or
3.
When the desired value is displayed, press

FB Edge Erase

This menu item sets the size, in millimeters, of the no print are around a flatbed scan job. Copy jobs will use the
setting or two millimeters, whichever is larger.
3-16
Service Manual
), and press Select (
).
3-15.
3-15.
to increase or decrease the setting's value.
).
).
).
).
.
).
).