Lexmark 7462 series Service Manual page 265

Input Source Test
1
From the Diagnostics menu, select PRINT TESTS.
2
Select a media source to test:
•
Tray 1 (standard tray)
•
Tray 2
•
Tray 3
•
Tray 4
•
Tray 5
•
MP Feeder
•
Envelope Feeder
Note: Trays 2–5 and the feeders are optional and are only available if installed.
3
Select one of the following:
•
Single—A single sheet is printed.
•
Continuous—Printing continues until the Stop button is pressed to cancel the test.
Note: If the input source contains envelopes, then an envelope test pattern is printed. Even if Continuous
is selected, the test pattern is only printed on the first envelope.
4
Touch Back to return to PRINT TESTS.
Note: Print Test Page always prints on one side of the paper even if duplex printing is enabled.
Print Quality Pages
This allows printing of the print quality pages with the toner cartridge lockout‑function disabled. The Print Quality
Test pages are printed in English and must always be printed on letter, legal, or A4 paper.
1
From the Diagnostics menu, select PRINT TESTS.
2
Touch the right arrow button beside Printing Quality Test Pages to start printing.
Note: The print quality test pages can also be printed from the Configuration menu (CONFIG MENU).
However, a cartridge must be installed with a machine class ID mathcing the machine class ID stored in
NVRAM. Additional diagnostic information may be printed on the pages when printing from Diagnostics.
The following is included in the DIAGNOSTICS version of the print quality pages:
•
Values from EP SETUP (including fuser temperature, warm‑up time, transfer, print contrast, charge roll
settings, and gap adjust)
•
Contents of the EVENT LOG
•
Configuration information, including printer serial number, controller code level, engine code level, and
cartridge information.
•
Default values for the QUALITY MENU settings used to print the pages.
Service menus
265
7462