Ep Setup - Lexmark 7462 series Service Manual

Notes:
–
When the last digit or character is changed, press the select button to validate Configuration ID 1.
If the process is successful, then Submitting Selection and the value for configuration ID 2
–
appear on the display.
3
Enter configuration ID 2.
4
Depending on your printer model, touch Submit or press the Select button to apply the changes.
Note: The process is successful if Submitting Selection or a check mark, depending on your
printer model, appears on the display.
5
Restart the printer.
Edge to Edge
When enabled, this setting shifts all four margins (top, bottom, left, and right) to the physical edge of the page
(printable area of a supported paper size).
Set the setting to Off to restore normal margins.

EP SETUP

EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. This is also used to help
correct print quality problems.
1
From the Diagnostics menu, navigate to EP SETUP > EP Defaults.
2
Select one of the following:
•
Restore—To restore the default values.
•
Do Not Restore—To exit without changing the settings.
Fuser Temperature (Fuser Temp)
This setting adjusts the fuser temperature to solve problems with paper curl on low‑grade paper and problems
with letterheads on some types of media.
1
From the Diagnostics menu, navigate to EP SETUP > Fuser Temp.
2
Set the fuser temperature to Normal, Lower, or Lowest.
Note: Normal is the factory default setting.
Fuser Page Count
Note: The fuser page count can only be viewed.
From the Diagnostics menu, navigate to EP SETUP > Fuser Page Count.
Service menus
274
7462