Anti-Tip Latch Assembly Removal - Lexmark 7462 series Service Manual

3
Pull the drive roll gear (B), the shaft with spring (C), and the bevel out through the opening.
4
Remove the 550-sheet tray option drive shaft with spring.

Anti-tip latch assembly removal

Note: Carefully remove the base machine from the input option tray assembly before proceeding. The left
and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below are for
removing the left latch, but removing the right latch is similar.
1
Remove the 250-sheet media tray assembly. Go to
page 404.
2
Turn the drawer upside down, and unsnap the two hooks (A) securing the anti-tip latch assembly to the
drawer with a flathead screwdriver.
Note: The hooks might break when detaching the anti-tip assembly from the drawer.
A
"250-sheet media tray assembly removal" on
Repair information
415
A
B
C
A
7462