Lexmark 7462 series Service Manual page 220

910.xx–917.xx error messages
Error code Description
910.00 The pick arm motor has stalled or become
obstructed.
911.00 The pick arm motor encoder continues to detect
pulse after motor stops.
912.00 The pick arm motor does not rotate at the specified
speed.
913.00 The pick arm motor does not rotate at the specified
speed.
914.00 The pick arm motor encoder detection is lost during
normal operation.
914.01 The pick arm motor does not rotate at the specified
speed.
915.00 The redrive motor encoder detection is lost during
normal operation.
915.01 The redrive motor does not rotate at the specified
speed.
916.00 The duplex drive motor encoder detection is lost
during normal operation.
916.01 The duplex drive motor does not rotate at the
specified speed.
917.00 Problem with transfer — transfer servo start error.
920.xx error messages
Error code Description
920.00 Fuser does not maintain proper operating
temperature within steady state control.
920.01 The fuser hot roll took too long to heat up after
transitioning to new enhanced mode within
standby control only.
920.02 The fuser hot roll fell to far below desired
temperature while in standby control.
920.03 The fuser hot roll is too cool while checking for
slope change in standby.
920.04 The fuser hot roll is too cool when heating to
desired temperature after slope change within
standby control only.
920.06 The fuser hot roll temperature does not increase
while the lamp is turned on.
Action
Go to
page
Go to
on page
Go to
check" on page
Go to
page
Action
Go to
check" on page
Go to
page
Diagnostic information
220
"Pick arm motor service check" on
240.
"Redrive motor assembly service check"
240.
"Internal duplex drive motor service
241.
"Transfer problem service check" on
241.
"Fuser (920.00–920.04) failure service
242.
"Fuser (920.06) failure service check" on
243.
7462