Adf Edge Erase; Size Sensing - Lexmark CS310 Service Manual

Erase Hard Disk
This setting performs a wipe of the printer hard disk, erasing all data.
Warning—Potential Damage: This deletes all data on the printer hard disk, including downloaded fonts, macros, and
held jobs. Do not initiate a disk wipe if you have information on the printer that you want to save.
Available options:
•
Single Pass Erase—overwrites all data and the file system. This wipe is faster but less secure since it is possible to
retrieve the deleted data with forensic data‑retrieval techniques.
•
Multi Pass Erase—overwrites all data without rewriting the file system. This wipe is DoD 5220.22-M compliant since
the deleted data is irretrievable.
Note: If the printer is reset while a disk wipe operation is executing, then Corrupt Disk appears upon regaining
power.

ADF Edge Erase

The value of this setting determines the size in millimeters of the "no-print" zone around an ADF scan job.
To change this setting:
1
From the Configuration Menu, navigate to ADF Edge Erase.
2
Touch Left or Right to change the setting.
3
Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any changes.

Size sensing

B5/Executive
Due to engine limitations, Trays 1 through 4 cannot simultaneously sense executive and JIS-B5-size paper. The value
of this setting determines which of the two paper sizes these trays will sense automatically. This setting will apply to
all automatic trays, but not to the MP Feeder. The MP Feeder can support these paper sizes regardless of the value of
this setting.
Tray [x] sensing
By turning the tray [x] sensing setting to Auto, every input option equipped with size sensing hardware automatically
registers what size of paper it contains. When this setting is turned Off, the printer ignores the size detected by the
hardware and treats the input source as a non-sensing source. The media size can be set by the operator panel or the
data stream.
To change this setting:
1
From the Configuration menu, navigate to SIZE SENSING. The screen displays each size sensing equipped input
source and its current Size Sensing setting.
2
Select the appropriate input source.
3
Touch Left or Right to change the setting.
4
Touch Submit to save the setting, or touch Back to return to the Configuration menu without saving any changes.
Service menus
193
5027