LinkPoint AIO Reference Manual page 99

CODE
- Hyphen: One (1) second pause
, Comma: Two (2) second pause
Y Additional dial tone required
L Location in dial string to open the dial tone
listen window
M Indicates the presence of multiple terminals
using same phone; must be in dial string of
each terminal
P Used only when the 'M' code is supplied
and there is a dial prefix. When this code is
present, the "listening" of sound energy
between tone digits is suppressed until the
position of the 'P' code is reached. This
code is used in the multi-terminal same-line
setup where a second dial tone is produced
after a dial prefix. If the 'P' code is not used,
then the second dial tone will supply
enough energy even though it may appear
as if a different terminal is dialing.
S A '.2' second pause
T Listens for energy between dialing each
digit. This is only used with the 'M' code.
U If this character is NOT supplied anywhere
in the dial string, then a line status test of
'line busy' will cause a return code of "6" to
the application,
condition will return a "7" to the application.
If the 'U' code is supplied in the dial string,
then both "line busy" and "no-dial-tone"
conditions
application, and "7" will never be returned to
the application.
V Suppresses LINE STATUS TEST
W Skips dial tone requirement
X Slow dial speed: 100 milliseconds on/off
© 2003 LinkPoint International, Inc.
This information is Proprietary and Confidential to LinkPoint International - Reproduction without the
expressed, written consent of LinkPoint International is prohibited.
DESCRIPTION
and a "no-dial-tone"
will return a "6"
ENTRY POSITION
Where the pause is required
Where the pause is required
Where dial tone is required
The point
terminal needs to check for
tone
Anywhere in dial string
Where the "listening" is to be
enabled
Where the pause is required
Anywhere in dial string
Anywhere in dial string
to the
Anywhere in dial string
Anywhere in dial string
Anywhere in dial string
90 L4CGS33 Reference Manual
at which the