Configuring Jumbo Frames; Adding Comments To An Interface - Avaya 2330 Manual

Secure Router 2330/4134 Ethernet interfaces configuration
<slot/port>

Configuring jumbo frames

The Secure Router 2330/4134 supports jumbo frames.
Important:
The Secure Router 2330/4134 management Ethernet interface (FE 0/0) on the rear panel
does not support jumbo frames. Therefore, the management port Maximum Transmission
Unit (MTU) can be configured with a value in the range of 64 to 1500 bytes.
Use the procedure in this section to configure the Secure Router 2330/4134 system settings
to support jumbo frames.
Procedure steps
1. To access configuration mode, enter:
2. To configure the system settings to support jumbo frames, enter:
3. Reboot the system.
Table 34: Variable definitions
<value>

Adding comments to an interface

Use the procedures in this section to add comments to an interface.
78 Configuration — Layer 2 Ethernet
Variable
configure terminal
system jumbo-mtu-limit <value>
Variable
Comments? infodev@avaya.com
Value
Specifies the slot and port numbers that
identify the port for configuration. For
example, 6/1.
Value
Valid values for the jumbo MTU limit are 1500
and 9216 bytes. The default value is 1500
bytes.
July 2013