Viewing Lag Interface Information; Example Of Configuring Lacp; Configuration On Switch_1 - Avaya 2330 Manual

Link aggregation configuration
Procedure steps
To view LACP dynamic information, enter:
show lacp dynamic {channel-group|detail|member-port}

Viewing LAG interface information

Use the procedure in this section to view information about interfaces, including LAG
interfaces.
Procedure steps
To view channel-group information, enter:
show bridge port

Example of configuring LACP

For the purposes of this example, the LACP mode on SWITCH_2 is configured as passive.
Avaya recommends, however, to always configure both ends as active.
Figure 15: Link aggregation group

Configuration on SWITCH_1

In this example, you aggregate lines 6/1 and 6/2 (between SWITCH_1 and SWITCH_2) as
channel group number 1 (lag1).
Procedure steps
1. To access configuration mode, enter:
112 Configuration — Layer 2 Ethernet
Comments? infodev@avaya.com
July 2013