Configuring A Maintenance End Point - Avaya 2330 Manual

Ethernet Connectivity Fault Management configuration
vlan <vid>

Configuring a Maintenance End Point

Use the procedure in this section to define an MEP within an MA. Each MEP and remote MEP
must have a unique ID within an MA. If two or more MEPs share the same ID, CFM raises an
event indicating a duplicate MEP exists in the MA.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create an MD, or to specify a previously created MD, enter:
5. To create an MA, or to specify a previously created MA, enter:
6. To create an MEP, enter:
Important:
The Secure Router 2330/4134 does not support the Fault Notification Generator (FNG) in
Release 10.1. You may see these parameters in the CLI for MEPs, but you cannot configure
this feature.
Table 16: Variable definitions
cc-state {enable|disable}
56 Configuration — Layer 2 Ethernet
Variable
configure terminal
oam
cfm
md <WORD>
ma <WORD>
mep <mep id> <interface id> mep-state {enable|disable} [cc-
state {enable|disable}]
Variable
Comments? infodev@avaya.com
Value
The VLAN ID with which to associate the MA.
The default value is 0 (untagged). Enter a
VID in the range 0 to 4000.
Value
Enable or disable the transmission of CCM
on the MEP. This parameter is optional. The
enable
default value is .
July 2013