Disabling Dynamic Vlan Creation - Avaya 2330 Manual

GVRP configuration
You configure dynamic VLAN creation on a device-by-device basis. GVRP does not
synchronize between devices, but adds VLANs only on devices that have dynamic creation
enabled in order to pass traffic between trunks.
To enable dynamic VLAN creation, all the trunk ports on the router must be 802.1Q and they
all must be GVRP-enabled ports. If the device has any non-802.1Q trunk ports, or if the 802.1Q
ports that exist are not configured for GVRP, you cannot enable the feature. VLANs are added
only for join messages received across a normal registration port.
Use the commands in this section to configure GVRP for dynamic VLAN creation.
Procedure steps
1. To access configuration mode, enter:
2. To access the GVRP command context, enter:
3. To enable dynamic VLAN creation, enter:

Disabling dynamic VLAN creation

Use the commands in this section to disable dynamic VLAN creation.
Procedure steps
1. To access configuration mode, enter:
2. To access the GVRP command context, enter:
3. To disable dynamic VLAN creation, enter:
170 Configuration — Layer 2 Ethernet
configure terminal
gvrp
dynamic-vlan-creation
configure terminal
gvrp
no dynamic-vlan-creation
Comments? infodev@avaya.com
July 2013