Chapter 18: Gvrp Configuration; Enabling Gvrp Globally; Disabling Gvrp Globally - Avaya 2330 Manual

Chapter 18: GVRP configuration

Use the procedures in this section to configure GVRP.
GVRP is primarily used to prune traffic from VLANs that do not pass between trunking switches.
In this section, GVRP is configured on Ethernet interfaces, but you can also configure GVRP on LAG
interfaces.

Enabling GVRP globally

By default, GVRP is not enabled for the switch. You must first enable GVRP on the switch
before you can configure the 802.1Q ports for GVRP operation.
Use the commands in this section to enable GVRP globally.
Procedure steps
1. To access configuration mode, enter:
2. To access the GVRP command context, enter:
3. To enable GVRP globally, enter:

Disabling GVRP globally

Use the commands in this section to disable GVRP globally. These commands do not disable
GVRP on all ports of the bridge. See
Procedure steps
1. To access configuration mode, enter:
2. To access the GVRP command context, enter:
Configuration — Layer 2 Ethernet
configure terminal
gvrp
gvrp-enable
configure terminal
Disabling GVRP on an interface on page 169.
July 2013 167