Configuring Gvrp Timers - Avaya 2330 Manual

Configuring GVRP timers

Use the gvrp timer command to adjust the values of the join, leave, and leaveall timers.
Timer values are in centi-seconds and valid values are from 1 to 10000. You must maintain
the following relationship for the various timer values:
• Leave time must be greater than or equal to three times the join time.
• Leaveall time must be greater than the leave time.
Use the command in this section to configure GVRP timers. This procedure is optional.
Procedure step
1. To access configuration mode, enter:
2. To select an Ethernet interface, enter:
3. To access the GVRP command context, enter:
4. To configure the GVRP timer, enter:
Table 93: Variable definitions
join <value>
leave <value>
Configuration — Layer 2 Ethernet
configure terminal
interface [range] ethernet <slot/port>
gvrp
timer join <value> leave <value> leaveall <value>
Variable Value
Join timer: each GARP application entity
sends a "join" message twice, for reliability,
and uses a join timer to set the sending
interval.
The timer value is expressed in centi-
seconds. Valid values are in the range 1 to
10000.
The join timer default is 20.
The Leave timer starts upon receipt of a
"leave" message sent for deregistering
attribute information. If no join message is
received before this timer expires, the GARP
application entity removes the attribute
information, as requested.
The timer value is expressed in centi-
seconds. Valid values are in the range 1 to
10000.
Configuring GVRP timers
July 2013 171