Verifying An Access Port; Configuring An Access Port On A Wan Interface; Enabling An Access Link On A Wan Interface - Avaya 2330 Manual

Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To disable the selected access port, enter:

Verifying an access port

Use the procedure in this section to verify the successful configuration of an access port. With
Release 10.2 and later, the show interface ethernet command displays the highest
supported capability for each interface: FE for Fast Ethernet and GE for Gigabit Ethernet.
Procedure steps
1. To view information related to the interface mode, enter:
2. To view information related to the operation of the access port, enter:

Configuring an access port on a WAN interface

Use the procedures in this section to configure a WAN interface as an access link.

Enabling an access link on a WAN interface

Use the procedure in this section to enable an access link between the devices.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To link the interface to the bundle, enter:
Configuration — Layer 2 Ethernet
configure terminal
interface [range] ethernet <slot/port>
no switchport
show bridge port
show interface ethernet <slot/port>
configure terminal
interface bundle <bundle-name>
Configuring an access port on a WAN interface
July 2013 101