Configuring A Hybrid Link On A Wan Interface; Enabling A Hybrid Link On A Wan Interface - Avaya 2330 Manual

Interface mode configuration
3. To configure the interface as a Layer 2 interface, enter:
4. To configure the interface as a hybrid link, enter:

Configuring a hybrid link on a WAN interface

Use the procedures in this section to configure and enable a hybrid link on a WAN interface.

Enabling a hybrid link on a WAN interface

Use the procedure in this section to enable a hybrid link between devices.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To link the interface to the bundle, enter:
4. To configure the encapsulation for the bundle, enter:
5. To configure the interface as a Layer 2 interface, enter:
6. To configure the interface as a hybrid port, enter:
Table 40: Variable definitions
<bundle-name>
{ppp | fr}
96 Configuration — Layer 2 Ethernet
switchport
switchport mode hybrid
configure terminal
interface bundle <bundle-name>
link <type> <slot/port>
encapsulation {ppp|fr}
switchport
switchport mode hybrid
Variable
Comments? infodev@avaya.com
Value
Specifies the name of the bundle. For
example, T1IF.
Specifies the encapsulation. You can
configure a hybrid link only on WAN
interfaces that are configured with PPP or FR
encapsulation.
July 2013