Configuring Link Path Cost And Priority For An Instance - Avaya 2330 Manual

Table 84: Variable definitions
<instance id>
<value>

Configuring link path cost and priority for an instance

Use the procedures in this section to configure the link path cost and priority for an instance.
Assigning port path cost in an instance (Internal Spanning Tree)
Use the procedure in this section to set the cost of a path for an MSTP instance.
Procedure steps
1. To access configuration mode, enter:
2. To select an Ethernet interface, enter:
3. To access the Spanning Tree command context, enter:
4. To select an MSTP instance, enter:
5. To configure the path cost for the instance, enter:
Table 85: Variable definitions
<instance id>
Configuration — Layer 2 Ethernet
no priority <value>
Variable
configure terminal
interface ethernet <slot/port>
spanning-tree
instance <instance id>
path-cost <value>
Variable
Value
Specifies the MSTP instance ID. Valid values
are 0 to 15.
Specifies the priority that you assign to the
instance. The default value for priority is
32768. Bridge priority values are in
increments of 4096. Valid values are 0 to
61440.
Value
Specifies the MSTP instance ID. Valid values
are 0 to 15.
Configuring an MSTP instance
July 2013 161